[6081] in RedHat Linux List

home help back first fref pref prev next nref lref last post

Re: This is it thread....

daemon@ATHENA.MIT.EDU (Elliot Lee)
Mon Nov 25 18:15:21 1996

Date: Mon, 25 Nov 1996 17:27:15 -0500 (EST)
From: Elliot Lee <sopwith@cuc.edu>
Reply-To: Elliot Lee <sopwith@cuc.edu>
To: redhat-list@redhat.com
In-Reply-To: <199611252116.NAA08327@ridge.spiritone.com>
Resent-From: redhat-list@redhat.com

On Mon, 25 Nov 1996, Dave wrote:

> > Have you recompiled your kernel with the sound module?
> > 
> Yes, in the make menuconfig there is a option that you can enable for the
> Ensoniq Soundscape card. However, where the problem seems to come 
> from is the MPU-401 conflict. I have also enabled this in the setup and
> kenerl builds but it still dosnt work

Well first I must defend support@redhat.com by saying this is definitely
not covered by the support agreement, to my knowledge.

Try turning off MPU-401 support and see how far you can get things.

> > > 2) Redhat 4.0 does not support the HP Colorado 1400 Tape Back Up
> > > Unit. I have read all the howto's and done everything I was supposed
> > > to do according to them and still nadda.
> > 
> > OK, what type of tape backup unit is this? Is it SCSI? Ftape?
> > 
>
> It is an IDE tape drive set off the floopy controler.

OK, when you try to access it, what modules load, and what messages are
logged in /var/log/messages?

> I opted to add MetroX in the inital install of RH 4.0. After a bootup I ran
> the configX.curses and configX. Selected the Matrox MGA Mill. 4meg
> card and chose 1024x768 at 16bit. The Gateway Vivitron is built by MAG.
> So in the monitor list I chose the MAG that fit the monitor I have. (I
> THINK)
> See here is a problem the RH Tech guys should be telling me. Am I
> in fact using the right config for this monitor. Anyway, when I run MetroX
> in a mode higher than 800x600 the scree turns into what looks like a 
> waterfall.

OK, I think you need to read the manual for your monitor, and feed those
numbers into configX - it sounds like that would be the problem.

Hope this helps,
-- Elliot

http://www.redhat.com/



--
  PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
  ________________________________________________________________________
  http://www.redhat.com/RedHat-FAQ   http://www.redhat.com/RedHat-Errata
  http://www.redhat.com/RedHat-Tips  http://www.redhat.com/mailing-lists
  ------------------------------------------------------------------------
To unsubscribe: mail -s unsubscribe redhat-list-request@redhat.com < /dev/null


home help back first fref pref prev next nref lref last post