[95669] in RedHat Linux List

home help back first fref pref prev next nref lref last post

Re: What is best driver for Logitech MouseMan M-CV46

daemon@ATHENA.MIT.EDU (William W. Austin)
Tue Oct 20 08:54:15 1998

From: "William W. Austin" <bill@baustin.alph.att.com>
Date: Tue, 20 Oct 1998 12:53:11 +0000 (   )
To: redhat-list@redhat.com
Resent-From: redhat-list@redhat.com
Reply-To: redhat-list@redhat.com

Patrick Hays <pjh@cstone.net> wrote:

> I have one of the newer Logitech mice with 3 buttons on top and one on
> side for thumb.  I think it should be a PS/2 type but that doesn't seem
> to work so I bought a PS/2<->serial adaptor and am using it as a
> straight MS-serial with 3 button emulation.  This works but not real
> well.
> 
> Does anyone else have this mouse installed to use middle button or even
> -gasp- the thumb button?  Also I'd like to free up my serial port...

That's exactly what I'm using now -- I plugged it into the PS/2 mouse port on 
the back of my system and it worked normally as a PS/2 mouse.  Does it work
correctly as a PS/2 mouse under windoze etc?  You could have a defective mouse.
I haven't tried the serial trick, but it would seem logical that if the mouse
was bad, then that would work slowly at best or most likely not at all.  Do you
have another PS/2 mouse to try (or can you borrow one)?  If anothe PS/2 mouse
didn't work, then that might be a dead giveaway (like perhaps the ps/2 internal
connector isn't plugged in correctly any more... etc.)

Just my $0.02 worth...


William W. Austin 			waustin@romulan.alph.att.com
					770 750-6954 VOICE / 770 750-7321 FAX
===============================================================================
		"Life is just a phase I'm going through..."


-- 
  PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
		http://www.redhat.com http://archive.redhat.com
         To unsubscribe: mail redhat-list-request@redhat.com with 
                       "unsubscribe" as the Subject.


home help back first fref pref prev next nref lref last post