[8718] in linux-scsi channel archive
Re: Unable to add a new Disk !!!
daemon@ATHENA.MIT.EDU (Marc SCHAEFER)
Thu Apr 27 01:41:18 2000
To: linux-scsi@vger.rutgers.edu
From: Marc SCHAEFER <schaefer@alphanet.ch>
Date: 27 Apr 2000 07:39:05 +0200
Message-ID: <8e8jpp$jl7$1@vulcan.alphanet.ch>
S.Anand Kr <anand@triveni.mnrec.ernet.in> wrote:
> disk (With a convertor) of Seagate make model ST34520W as id 1, the system
The convertor might be your problem. Please give exact details of
SCSI bus topology, host adapter configuration (ie termination ON/OFF/AUTO/
HIGH/LOW), especially cable width, etc.
> Vendor: Seagate Model: xxxx Rev: xxxx
> Type: xxxx ANSI SCSI Revision: xx
did you obfuscate this, or was this reported as is ?
> Detected SCSI disk sda at scsi0, channel 0, id 0, lun 0
> (scsi0:0:1:0) Parity error during message-In phase
This doesn't look like a wide disk/host, non wide cable problem
since it didn't crash in a data phase. However it could be
bad, inexistant or double termination.
> Kindly rectify the problem.
hum. I can send a hammer if required.
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@vger.rutgers.edu
