[4808] in linux-scsi channel archive
Re: aic7xxx testers needed
daemon@ATHENA.MIT.EDU (Rolf Fokkens)
Sat Oct 3 14:35:36 1998
Date: Sat, 03 Oct 1998 20:25:06 +0200
From: Rolf Fokkens <rolf@flits102-126.flits.rug.nl>
To: dledford@dialnet.net, linux-scsi@vger.rutgers.edu
> The aic7xxx-5.1.0-pre13 driver has just been released. This driver is
what
> I consider to be a final release candidate (except the debugging stuff
is
> still enabled). I would ask as many people as possible to please try
this
> version of the driver out and let me know if you have problems. If I
don't
> here back from people that there are problems in this driver, then it
will
> shortly become the official aic7xxx-5.1.0 driver for linux.
Serious problems here with pre13. The boot sequence now looks like this:
(scsi0) Downloading sequencer code... 419 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI)
5.1.13pre13/3.2.4
<Adaptec AHA-294X Ultra SCSI host adapter>
scsi : 1 host.
(scsi0:0:1:0) Synchronous at 20.0 Mbyte/sec, offset 15
scsi0: channel 0 target 1 lun 0 request sense failed, performing reset
SCSI bus being reset for host 0 channel 0
And this is all that happens. The pre15 I tried show the same.
The pre8 driver is OK and shows the following during boot:
scsi0) Downloading sequencer code... 419 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI)
5.1.0pre8/3.2.4
<Adaptec AHA-294X Ultra SCSI host adapter>
scsi : 1 host.
Vendor: IBM Model: DCAS-34330 Rev:S61A
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 1, lun 0
Vendor: IBM Model: DORS-32160 Rev: WABA
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 2, lun 0
Vendor: DEC Model: RZ28M (C) DEC Rev: 1104
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdc at scsi0, channel 0, id 4, lun 0
Vendor: PLEXTOR Model: CD-ROM PX-32TS Rev: 1.01
Type: CD-ROM ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
scsi : detected 1 SCSI cdrom 3 SCSI disks total.
(scsi0:0:1:0) Synchronous at 20.0 Mbyte/sec, offset 15.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 8467200 [4134 MB] [4.1
GB]
(scsi0:0:2:0) Synchronous at 20.0 Mbyte/sec, offset 15.
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 4226725 [2063 MB] [2.1
GB]
(scsi0:0:4:0) Synchronous at 10.0 Mbyte/sec, offset 15.
SCSI device sdc: hdwr sector= 512 bytes. Sectors= 4110480 [2007 MB] [2.0
GB]
Partition check:
I'm sure that at pre10 was OK like pre8, and I think pre11 was OK too.
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@vger.rutgers.edu
