[343] in linux-scsi channel archive
AHA 2940 bootup failure
daemon@ATHENA.MIT.EDU (Archie Cobbs)
Tue Jul 11 21:48:58 1995
From: Archie Cobbs <archie@CS.Berkeley.EDU>
To: linux-scsi@vger.rutgers.edu
Date: Tue, 11 Jul 1995 11:50:14 -0700 (PDT)
Hi, I just rejoined this list so I apologize if this has already been covered.
Trying to boot Linux 1.3.8 with an AHA-2940 PCI SCSI card I get a lock-up
after the last line below (this was typed in by hand, pardon any typos):
aic7xxx: hcntrl = 0x2
aic7xxx_detect: AIC-7870 Rev B
aic7xxx_detect: devconfig 0x0, devstatus 0x5
aic7870 hcntrl = 0x5
aic78xx: Reading SEEPROM... done
aic7870: extended translation enabled
AIC7870 (PCI-bus):
irq 11
bus release time 40 bclks
data fifo threshold 100%
SCSI CHANNEL A:
scsi id 7
scsi selection timeout 356 ms
scsi bus reset at power-on enabled
scsi bus parity enabled
scsi bus termination (low byte) enabled
aic7xxx: Dowloading sequencer code... done.
NeedSdtr = 0xff, 0xff
NeedWdtr = 0x0, 0x0
Resetting the SCSI bus...
When I boot without the driver installed, I can cat /proc/pci
and see this:
0 Device 10 Function 0.
SCSI bus controller : Adaptec 2940 (rev 0). 8259's interrupt 11.
Thanks for any help!
-Archie
