[97140] in North American Network Operators' Group
Re: IPv6 Training?
daemon@ATHENA.MIT.EDU (Petri Helenius)
Sun Jun 3 02:50:56 2007
Date: Sun, 03 Jun 2007 09:49:14 +0300
From: Petri Helenius <pete@he.iki.fi>
To: simon@limmat.switch.ch
Cc: Alex Rubenstein <alex@corp.nac.net>, NANOG <nanog@merit.edu>
In-Reply-To: <aahcpspo6j.fsf@switch.ch>
Errors-To: owner-nanog@merit.edu
simon@limmat.switch.ch wrote:
> Alex Rubenstein writes:
>
>> Does anyone know of any good IPv6 training resources (classroom, or
>> self-guided)?
>>
>
> If your router vendor supports IPv6 (surprisingly, many do!):
>
Too bad the IPv6 support on the low-end Ciscos is mostly broken in many
ways (does not work on WLAN, does not work across the local 4 port
switch, etc.) , which are also the routers most classrooms could afford.
Pete
> lab-router#conf t
> Enter configuration commands, one per line. End with CNTL/Z.
> lab-router(config)#ipv6 ?
> access-list Configure access lists
> cef Cisco Express Forwarding for IPv6
> dhcp Configure IPv6 DHCP
> general-prefix Configure a general IPv6 prefix
> hop-limit Configure hop count limit
> host Configure static hostnames
> icmp Configure ICMP parameters
> local Specify local options
> mfib Multicast Forwarding
> mfib-mode Multicast Forwarding mode
> mld Global mld commands
> multicast-routing Enable IPv6 multicast
> neighbor Neighbor
> ospf OSPF
> pim Configure Protocol Independent Multicast
> prefix-list Build a prefix list
> route Configure static routes
> router Enable an IPV6 routing process
> unicast-routing Enable unicast routing
>
> lab-router(config)#ipv6 unicast-routing
> lab-router(config)#interface tengigabitEthernet 1/1
> lab-router(config-if)#ipv6 ?
> IPv6 interface subcommands:
> address Configure IPv6 address on interface
> cef Cisco Express Forwarding for IPv6
> dhcp IPv6 DHCP interface subcommands
> enable Enable IPv6 on interface
> mfib Interface Specific MFIB Control
> mld interface commands
> mtu Set IPv6 Maximum Transmission Unit
> nd IPv6 interface Neighbor Discovery subcommands
> ospf OSPF interface commands
> pim PIM interface commands
> policy Enable IPv6 policy routing
> redirects Enable sending of ICMP Redirect messages
> rip Configure RIP routing protocol
> router IPv6 Router interface commands
> traffic-filter Access control list for packets
> unnumbered Preferred interface for source address selection
> verify Enable per packet validation
>
> lab-router(config-if)#ipv6 enable
> [...]
>
> And then chances are good that you find useful training material on
> their Web sites, often not just command descriptions, but actual
> deployment guides.
>
