|
|
|
|
|
|
|
|
|
|
|
|
| home | help | back | first | fref | pref | prev | next | nref | lref | last | post |
Date: Wed, 21 Apr 1999 22:42:47 -0400 From: Charles Galpin <cgalpin@lighthouse-software.com> To: linux-scsi <linux-scsi@vger.rutgers.edu> In case I'm wearing out my welcome, I'd just like to thank everyone for their input. >See if it can verify the drive. If not, >then you've definitely got a cable or termination problem. If it can, >especially at the higher speeds, then it's a software issue. verified w/ the adaptec bios just fine, with the transfer rate @ 80mb too >Have you set up the BIOS to send out spin-up command to the disk(s)? yes, this has been on through all tests >Oh, just one more thing. Have you tried to blacklist the disk so >that the non-zero LUN probe is not performed on the disk? Among my >disk, the Quantum Empire 1GB disk caused a problem when the non-0 LUN >probe is done against the unit. It would lock the bus. So I >blacklisted it in my copy of the linux source and now don't see the >problem any more. I am writing this on a Sun box, but the file in >question is scsi.c if I recall correctly. The bios has "BIOS Multiple LUN Support" off. If I get a system up, I'll try this though >Check the jumpers of the disk and use preferently the most conservative >and most simple possible setup. For example, configure it for not >initiating negotiations. turned of initiating negotiations, disconnect, wide negotiations, lowered tranfer rate to 40 on all ids - no difference Still cannot get the MB to recognize my IDE HD. I'm going to have to try this drive on a another machine to make sure it's ok (a year old but never used). thanks Charles - To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@vger.rutgers.edu
|
|
|
|
|
|
|
|
|
|
|
|
| home | help | back | first | fref | pref | prev | next | nref | lref | last | post |