[5248] in linux-scsi channel archive
Lockup with new Mylex/BusLogic 2.0.15 driver.
daemon@ATHENA.MIT.EDU (Floody)
Tue Dec 1 00:33:58 1998
Date: Mon, 30 Nov 1998 17:05:51 -0500
From: Floody <flood@evcom.net>
To: linux-scsi@vger.rutgers.edu
Cc: lnz@dandelion.com
Greetings.
I am experiencing a lockup using the new BusLogic 2.0.15 driver present in the
2.0.36 kernel. 2.0.14 from 2.0.35 works like a champ, and has for many moons.
My controller is the BT958UW.
The box in question is a PII-266, 128M EDO. The only other cards in the box
are a fairly generic SVGA PCI card and a DE500BA NIC (also PCI). At boot, the
driver properly detects the host adapter, displays it's information, and then
locks hard after "scsi : 1 host." No attached scsi device information is
displayed. My BusLogic driver is compiled statically, rather than as a
module.
The following is boot output from 2.0.14/2.0.35, just so you can see how the
host adapter is configured (all settings reported match the settings in
AutoSCSI).
scsi: ***** BusLogic SCSI Driver Version 2.0.14 of 29 April 1998 *****
scsi: Copyright 1995-1998 by Leonard N. Zubkoff <lnz@dandelion.com>
scsi0: Configuring BusLogic Model BT-958 PCI Wide Ultra SCSI Host Adapter
scsi0: Firmware Version: 5.07B, I/O Address: 0xEFF4, IRQ Channel: 11/Level
scsi0: PCI Bus: 0, Device: 13, Address: 0xFEBFF000, Host Adapter SCSI ID: 7
scsi0: Parity Checking: Enabled, Extended Translation: Enabled
scsi0: Synchronous Negotiation: UFFFFFF#FFFFFFFF, Wide Negotiation: Enabled
scsi0: Disconnect/Reconnect: Enabled, Tagged Queuing: Enabled
scsi0: Scatter/Gather Limit: 128 of 8192 segments, Mailboxes: 211
scsi0: Driver Queue Depth: 211, Host Adapter Queue Depth: 192
scsi0: Tagged Queue Depth: Automatic, Untagged Queue Depth: 3
scsi0: Error Recovery Strategy: Default, SCSI Bus Reset: Enabled
scsi0: SCSI Bus Termination: Both Enabled, SCAM: Disabled
scsi0: *** BusLogic BT-958 Initialized Successfully ***
scsi0 : BusLogic BT-958
scsi : 1 host.
Vendor: SEAGATE Model: ST19171W Rev: 0024
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
scsi0: Target 0: Queue Depth 28, Wide Synchronous at 40.0 MB/sec, offset 15
scsi : detected 1 SCSI disk total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 17783112 [8683 MB] [8.7 GB]
Partition check:
sda: sda1 sda2 sda3 sda4
VFS: Mounted root (ext2 filesystem) readonly.
scsi0: Tagged Queuing now active for Target 0
Any ideas?
Thanks!
--
"I look around me .. and all I see are surfaces .. without depth."
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@vger.rutgers.edu
