[4483] in linux-scsi channel archive
problems with AIC7890 SCSI on Slackware 3.5
daemon@ATHENA.MIT.EDU (Lavender, Ben)
Fri Jul 31 10:16:38 1998
From: "Lavender, Ben" <Lavender.Ben@mtvne.com>
To: "'linux-scsi@vger.rutgers.edu'" <linux-scsi@vger.rutgers.edu>
Date: Fri, 31 Jul 1998 15:04:07 +0100
Please help - I'm really stuck - I'm new to Linux. I'm trying to
install
Slackware 3.5 on:
a new Dell PowerEdge Server 2300. It has an on-board AIC-7890 (for the
hard-disk) and AIC-7860 (for the CD-Rom) on booting Slackware using the
aha2x4x.s image. It detects the AIC-7860 and the CD-ROM but can't detect
the AIC-7890 and harddisk.
The harddisk is on SCSI No. # 0
It's a Seagate ST34572wC Ultra2-SE
This is what I get:
(scsi0) <Apaptec AIC-7860 Ultra SCSI host adapter> found at PCI 6/0
(scsi0) Narrow Channel, SCSI ID=7, 2/555 SCBs
(scsi0) Bios enabled, IO Port 0xe800, IRQ14
(scsi0) IO Memory at 0xf9ffe000, MMAP Memory at 0x4805000
(scsi0) Reseting Channel
(scsi0) Downloading sequencer code... 413 instructions downloaded
(scsi0) Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.0.14/3.2.4
scsi0 : 1 host.
(scsi0:-1:-1:-1) Scanning channel for devices.
(scsi0:-1:-1:-1) Synchronous at 20.0MHZ, offset 15.
Vendor: NEC Model: CD-ROM DRIVE:464 Rev: 1.05
Type: CD-ROM ANSI SCSI revision: 02
Detected 1 SCSI CD-ROM sr0 at scsi0, channel 0, id 5, lun0
scsi : detected 1 SCSI cdrom total.
Partition check:
(scsi0:-1:-1:-1) Bad scbptr 255 during SELTO
(scsi0:-1:-1:-1) Referenced SCB 255 not valid during SELTO
SCSISEQ = 0x12 SEQADDR = 0xa SSTAT0 = 0x10 SStAT1 = 0x8a
Does Slackware support the Adaptec AIC7890? Or do you know where I can
get
the driver.
Please help - I'd be very greatful if you could.
Thanks
Ben ( ben.lavender@cygnet.co.uk )
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@vger.rutgers.edu
