[3418] in linux-scsi channel archive
No subject found in mail header
daemon@ATHENA.MIT.EDU (katef@uctvms.uct.ac.za)
Sat Feb 28 07:33:59 1998
Date: Sat, 28 Feb 1998 14:31:18 +0200
From: katef@uctvms.uct.ac.za
To: linux-scsi@vger.rutgers.edu
Hello
I'm trying to use an adaptec 1542B scsi board with linux (Red Hat 4.2).
Connected to the scsi board is a dat tape and a hard disk.
I've tried both reconfiguring the kernel and also loading the boot
installation software again and I get a message that goes something like
scsi detected at scsi-id 7 io:330 irq11 dma 7
scsi0 adaptec
scsi 1 host
scsi: aborting command due to timeout: pid 0, scsi 0, id 0 lun 0 Test unit
ready 00 00 00 00
scsi host 0 abort (pid0) timeout - reseting
scsi bus being reset for host 0 channel 0
sent bus device reset to target 0
sending DID_RESET for target 0
" " " "
then the message starts again from scsi: aborting command.....
In the documentation the only options are io,buson,busoff,dmaspeed.
Buson/off isn't in the jumper selection.
Are the jumpers on the board set wrong? As far as I can tell they are set
to the standard settings.
Thanks for any help anyone has to offer
Robin
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@vger.rutgers.edu
