[3342] in linux-scsi channel archive
scsi : 0 hosts
daemon@ATHENA.MIT.EDU (Daniel Joubert)
Mon Feb 16 04:06:51 1998
From: "Daniel Joubert" <joubert@physnet.phys.wits.ac.za>
To: linux-scsi@vger.rutgers.edu
Date: Mon, 16 Feb 1998 11:01:25 +0000
Reply-to: joubert@physnet.phys.wits.ac.za
I have installed Linux Redhat v5.0 on a P133 with an IDE and SCSI
drive (SCSI controller - Adaptec AHA-294x/AIC-78XX PCI SCSI
controller with a Conner CFP10602 1.05 GB). The SCSI is BIOS
detecte (Adaptec AHA-2940 BIOS v1.16). During installation the SCSI
drive is detected and set up correctly at the SCSI bus scanning stage
and I was able to partion, format and write to it. During normal
bootup the message
scsi : 0 hosts
is given (during installation as well) and I cannot acces this drive.
Using Win95 Device Manager it appears to me that the SCSI controller
uses memory
000C8000h-000CA7FFh and and F200000-F2000FFFh. The DOS debug
command,
'debug
-d c800:0'
gives the following:
-d c800:0
C800:0000 55 AA 14 E9 CA 26 00 00-00 00 00 00 00 00 00 00
U....&..........
C800:0010 00 00 00 00 00 00 00 00-4D 00 41 64 61 70 74 65
........M.Adapte
C800:0020 63 20 42 49 4F 53 3A 41-48 41 2D 32 39 34 30 01 c
BIOS:AHA-2940.
C800:0030 16 43 6F 70 79 72 69 67-68 74 20 41 64 61 70 74
.Copyright Adapt
C800:0040 65 63 2C 20 49 6E 63 2E-20 31 39 39 35 50 43 49 ec, Inc.
1995PCI
C800:0050 52 04 90 78 71 00 00 18-00 00 00 00 01 40 00 00
R..xq........@..
C800:0060 00 00 80 00 00 00 00 00-07 01 A4 9E 00 F0 08 00
................
C800:0070 16 00 00 00 00 00 00 00-00 00 00 00 00 00 00 00
................
-q
I'll appreciate help very much.
Thank you
Daniel Joubert
Dr. Daniel Joubert email: joubert@physnet.phys.wits.ac.za
Physic Department Telephone: +27 11 7163059
University of the Witwatersrand Fax: +27 11 339 8262
PO Wits, Johannesburg 2050
South Africa
