[2036] in linux-scsi channel archive
Accessing a SCSI dat tape in Linux
daemon@ATHENA.MIT.EDU (William Bell)
Fri Jun 20 09:51:06 1997
Date: Fri, 20 Jun 1997 09:44:50 -0400
From: William Bell <tes@topeng.com>
Reply-To: tes@topeng.com
To: scsi -linux <linux-scsi@vger.rutgers.edu>
This is a multi-part message in MIME format.
--------------7E302FD3378D
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit
Hi,
I have Linux Red hat version 4.1 and I can't seem to get my SCSI HP dat
tape to mount.
At bootup, linux seems to identify it and does not assign a /dev/st?.
I've looked thru HOWTO and havn't seen the ans.
Can you point meto the location where the answer is or give me a bit of
guidance?
THX
Bill Bell
--------------7E302FD3378D
Content-Type: text/plain; charset=us-ascii; name="Boot.msg"
Content-Transfer-Encoding: 7bit
Content-Disposition: inline; filename="Boot.msg"
onsole (max 63)
pcibios_init : BIOS32 Service Directory structure at 0x000fd990
pcibios_init : BIOS32 Service Directory entry at 0xfd9a0
pcibios_init : PCI BIOS revision 2.10 entry at 0xfd9c1
Probing PCI hardware.
Calibrating delay loop.. ok - 199.07 BogoMIPS
Memory: 62768k/65536k available (752k kernel code, 384k reserved, 1272k data)
Swansea University Computer Society NET3.035 for Linux 2.0
NET3: Unix domain sockets 0.13 for Linux NET3.035.
Swansea University Computer Society TCP/IP for NET3.034
IP Protocols: ICMP, UDP, TCP
VFS: Diskquotas version dquot_5.6.0 initialized
Checking 386/387 coupling... Ok, fpu using exception 16 error reporting.
Checking 'hlt' instruction... Ok.
Linux version 2.0.27 (root@porky.redhat.com) (gcc version 2.7.2.1) #1 Sat Dec 21 23:44:11 EST 1996
Serial driver version 4.13 with no serial options enabled
tty00 at 0x03f8 (irq = 4) is a 16550A
tty01 at 0x02f8 (irq = 3) is a 16550A
PS/2 auxiliary pointing device detected -- driver installed.
Ramdisk driver initialized : 16 ramdisks of 4096K size
hdc: FX800S, ATAPI CDROM drive
ide1 at 0x170-0x177,0x376 on irq 15
Floppy drive(s): fd0 is 1.44M
Started kswapd v 1.4.2.2
FDC 0 is a National Semiconductor PC87306
md driver 0.35 MAX_MD_DEV=4, MAX_REAL=8
scsi : 0 hosts.
scsi : detected total.
Partition check:
RAMDISK: Compressed image found at block 0
VFS: Mounted root (ext2 filesystem).
aic7xxx: BurstLen = 8 DWDs, Latency Timer = 40 PCLKS
aic7xxx: AHA-2940A Ultra Rev C.
aic7xxx: devconfig = 0x1100.
aic7xxx: Reading SEEPROM...done.
aic7xxx: Extended translation enabled.
aic7xxx: Memory check yields 3 SCBs, paging not enabled.
AHA-2940A Ultra (PCI-bus), I/O 0xfc00, Mem 0xffbeb000:
irq 10
bus release time 40 bclks
data fifo threshold 100%
SCSI CHANNEL A:
scsi id 7
scsi selection timeout 256 ms
scsi bus reset at power-on enabled
scsi bus parity enabled
scsi bus termination (low byte) disabled
aic7xxx: Downloading sequencer code...done.
aic7xxx: Resetting the SCSI bus...done.
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 4.0/3.2/4.0
scsi : 1 host.
scsi0: Scanning channel A for devices.
scsi0: Target 0, channel A, now synchronous at 10.0MHz, offset 15.
Vendor: SEAGATE Model: ST32155N Rev: 0532
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
scsi0: Target 1, channel A, now synchronous at 10.0MHz, offset 15.
Vendor: FUJITSU Model: M2954S-512 Rev: 0142
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 1, lun 0
scsi0: Target 2, channel A, refusing synchronous negotiation; using asynchronous transfers.
Vendor: IOMEGA Model: ZIP 100 Rev: E.08
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi removable disk sdc at scsi0, channel 0, id 2, lun 0
scsi0: Target 5, channel A, now synchronous at 5.0MHz, offset 8.
Vendor: HP Model: HP35480A Rev: T503
Type: Sequential-Access ANSI SCSI revision: 02
SCSI device sda: hdwr sector= 512 bytes. Sectors= 4197405 [2049 MB] [2.0 GB]
sda: sda1
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 8498506 [4149 MB] [4.1 GB]
sdb: sdb1 sdb2 sdb3
SCSI device sdc: hdwr sector= 512 bytes. Sectors= 196608 [96 MB] [0.1 GB]
sdc: Write Protect is off
sdc: sdc4
VFS: Mounted root (ext2 filesystem) readonly.
Trying to unmount old root ... okay
Adding Swap: 128516k swap-space
Swansea University Computer Society IPX 0.34 for NET3.035
IPX Portions Copyright (c) 1995 Caldera, Inc.
Appletalk 0.17 for Linux NET3.035
loading device 'eth0'...
ne.c:v1.10 9/23/94 Donald Becker (becker@cesdis.gsfc.nasa.gov)
NE*000 ethercard probe at 0x320: 08 00 17 09 ab 08
eth0: NE2000 found at 0x320, using IRQ 5.
--------------7E302FD3378D--
