[1344] in linux-scsi channel archive
Re: (Fwd) (Fwd) Iomega Zip Drive (SCSI Version)
daemon@ATHENA.MIT.EDU (Joseph Possert)
Tue Jan 28 13:06:30 1997
From: "Joseph Possert" <joseph@voltec.com>
To: grant@knot.torque.net
Date: Tue, 28 Jan 1997 12:32:59 -0500
Reply-To: joseph@voltec.com
Cc: linux-scsi@vger.rutgers.edu
> > However, after I do some work with the Zip Disk (copy, read, open
> > files, etc.) and I umount the drive, and get a whole lot of errors
> > which are logged by the syslog daemon as facility Kern. The point
> > that concerns me is that this log looks almost identical to the log
> > when I boot up my linux box.
>
> You have a buggy syslog daemon. The messsages that you attached are
> ghosts.
>
> What does 'dmesg' show you this happens ?
>
> --------------------------------------------------------------------------
> Grant R. Guenther grant@torque.net
> --------------------------------------------------------------------------
>
>
Sorry,
Dmesg:
Disc change detected.
VFS: Disk change detected on device 08:14
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 196608 [96 MB] [0.1
GB] sdb: Write Protect is off
sdb: sdb4
kern facility of syslog daemon:
Jan 28 12:04:35 voltec kernel: Disc change detected.
Jan 28 12:04:35 voltec kernel: VFS: Disk change detected on device 08:14
Jan 28 12:04:35 voltec kernel: SCSI device sdb: hdwr sector= 512 bytes. Sectors= 196608 [96 MB] [0.1 GB]
Jan 28 12:04:35 voltec kernel: sdb: Write Protect is off
Jan 28 12:04:35 voltec kernel: sdb:bytes. Sectors= 196608 [96 MB] [0.1 GB]
Jan 28 12:04:35 voltec kernel: ber 40960
Jan 28 12:04:35 voltec kernel: 44
Jan 28 12:04:35 voltec kernel: read partition table
Jan 28 12:04:35 voltec kernel: a selection timer finished, 10baseT.
Jan 28 12:04:35 voltec kernel: annel allocation)
Jan 28 12:04:35 voltec kernel: TCP compression code copyright 1989 Regents of the University of California
Jan 28 12:04:35 voltec kernel: PPP Dynamic channel allocation code copyright 1995 Caldera, Inc.
Jan 28 12:04:35 voltec kernel: PPP line discipline registered.
Jan 28 12:04:35 voltec kernel: SLIP: version 0.8.4-NET3.019-NEWTTY (dynamic channels, max=256).
Jan 28 12:04:35 voltec kernel: CSLIP: code copyright 1989 Regents of the University of California.
Jan 28 12:04:35 voltec kernel: Overriding PCI latency timer (CFLT) setting of 96, new value is 255.
Jan 28 12:04:35 voltec kernel: eth0: 3Com 3c590 Vortex 10Mbps at 0xff80, 00:a0:24:bc:32:cc, IRQ 11
Jan 28 12:04:35 voltec kernel: Internal config register is 1020010, transceivers 0xe108.
Jan 28 12:04:35 voltec kernel: 8K byte-wide RAM 1:1 Rx:Tx split, autoselect/10baseT interface.
Jan 28 12:04:35 voltec kernel: 3c59x.c:v0.25 5/17/96 becker@cesdis.gsfc.nasa.gov
Jan 28 12:04:35 voltec kernel: wd.c:v1.10 9/23/94 Donald Becker (becker@cesdis.gsfc.nasa.gov)
Jan 28 12:04:35 voltec kernel: eth1: WD80x3 at 0x300, 00 00 C0 49 85 1A assigning address 0xd0000 WD8013, IRQ 10, shared memory at 0xd0000-0xd3fff.
Jan 28 12:04:35 voltec kernel: Partition check:
Jan 28 12:04:35 voltec kernel: sda: sda1
Jan 28 12:04:35 voltec kernel: sdb:scsidisk I/O error: dev 08:10, sector 0
Jan 28 12:04:35 voltec kernel: unable to read partition table
Jan 28 12:04:35 voltec kernel: hda: hda1 hda2 hda3 hda4
Jan 28 12:04:35 voltec kernel: hdb: hdb1 hdb2
Jan 28 12:04:35 voltec kernel: JAVA Binary support v1.01 for Linux 1.3.98 (C)1996 Brian A. Lantz
Jan 28 12:04:35 voltec kernel: VFS: Mounted root (ext2 filesystem) readonly.
Jan 28 12:04:35 voltec kernel: Adding Swap: 16092k swap-space
Jan 28 12:04:35 voltec kernel: Adding Swap: 16092k swap-space
Jan 28 12:04:35 voltec kernel: hdc: media changed
Jan 28 12:04:35 voltec kernel: hdc: media changed
Jan 28 12:04:35 voltec kernel: VFS: Disk change detected on device 16:00
Jan 28 12:04:35 voltec kernel: Max size:126369 Log zone size:2048
Jan 28 12:04:35 voltec kernel: First datazone:20 Root inode number 40960
Jan 28 12:04:35 voltec kernel: eth0: Initial media type 10baseT.
Jan 28 12:04:35 voltec kernel: eth0: vortex_open() InternalConfig 01020010.
Jan 28 12:04:35 voltec kernel: eth0: vortex_open() irq 11 media status 8800.
Jan 28 12:04:35 voltec kernel: ,0x3f6 on irq 14
Jan 28 12:04:35 voltec kernel: ide1 at 0x170-0x177,0x376 on irq 15
Jan 28 12:04:35 voltec kernel: Floppy drive(s): fd0 is 1.44M, fd1 is 1.44M
Jan 28 12:04:35 voltec kernel: Started kswapd v 1.4.2.2
Jan 28 12:04:35 voltec kernel: FDC 0 is a post-1991 82077
Jan 28 12:04:35 voltec kernel: aic7xxx: BurstLen = 8 DWDs, Latency Timer = 96 PCLKS
Jan 28 12:04:35 voltec kernel: aic7xxx: AHA-2940 Ultra Rev B.
Jan 28 12:04:35 voltec kernel: aic7xxx: devconfig = 0x1580.
Jan 28 12:04:35 voltec kernel: aic7xxx: Reading SEEPROM...done.
Jan 28 12:04:35 voltec kernel: aic7xxx: Enabling support for Ultra SCSI speed.
Jan 28 12:04:35 voltec kernel: aic7xxx: Extended translation enabled.
Jan 28 12:04:35 voltec kernel: aic7xxx: Memory check yields 16 SCBs, paging not enabled.
Jan 28 12:04:35 voltec kernel: aic7xxx: Enabling wide channel of AHA-2940 Ultra-Wide.
Jan 28 12:04:35 voltec kernel: AHA-2940 Ultra-WIDE (PCI-bus), I/O 0xfc00, Mem 0xffbdf000:
Jan 28 12:04:35 voltec kernel: irq 12
Jan 28 12:04:35 voltec kernel: bus release time 40 bclks
Jan 28 12:04:35 voltec kernel: data fifo threshold 100%
Jan 28 12:04:35 voltec kernel: SCSI CHANNEL A:
Jan 28 12:04:35 voltec kernel: scsi id 7
Jan 28 12:04:35 voltec kernel: scsi selection timeout 256 ms
Jan 28 12:04:35 voltec kernel: scsi bus reset at power-on enabled
Jan 28 12:04:35 voltec kernel: scsi bus parity enabled
Jan 28 12:04:35 voltec kernel: scsi bus termination (low byte) disabled
Jan 28 12:04:35 voltec kernel: scsi bus termination (high byte) enabled
Jan 28 12:04:35 voltec kernel: aic7xxx: Downloading sequencer code...done.
Jan 28 12:04:35 voltec kernel: aic7xxx: Resetting the SCSI bus...done.
Jan 28 12:04:35 voltec kernel: scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 4.0/3.2/4.0
Jan 28 12:04:35 voltec kernel: scsi : 1 host.
Jan 28 12:04:35 voltec kernel: scsi0: Scanning channel A for devices.
Jan 28 12:04:35 voltec kernel: scsi0: Received MSG_WDTR, Target 0, channel A needwdtr(0xffff).
Jan 28 12:04:35 voltec kernel: scsi0: Target 0, channel A, now synchronous at 10.0MHz, offset 15.
Jan 28 12:04:35 voltec kernel: Vendor: SEAGATE Model: ST12400N Rev: 8650
Jan 28 12:04:35 voltec kernel: Type: Direct-Access ANSI SCSI revision: 02
Jan 28 12:04:35 voltec kernel: Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
Jan 28 12:04:35 voltec kernel: scsi0: Target 4, channel A, refusing WIDE negotiation; using 8 bit transfers.
Jan 28 12:04:35 voltec kernel: scsi0: Target 4, channel A, refusing synchronous negotiation; using asynchronous transfers.
Jan 28 12:04:35 voltec kernel: Vendor: HP Model: T4000s Rev: 1.06
Jan 28 12:04:35 voltec kernel: Type: Sequential-Access ANSI SCSI revision: 02
Jan 28 12:04:35 voltec kernel: Detected scsi tape st0 at scsi0, channel 0, id 4, lun 0
Jan 28 12:04:35 voltec kernel: scsi0: Target 5, channel A, refusing WIDE negotiation; using 8 bit transfers.
Jan 28 12:04:35 voltec kernel: scsi0: Target 5, channel A, refusing synchronous negotiation; using asynchronous transfers.
Jan 28 12:04:35 voltec kernel: Vendor: IOMEGA Model: ZIP 100 Rev: D.09
Jan 28 12:04:35 voltec kernel: Type: Direct-Access ANSI SCSI revision: 02
Jan 28 12:04:35 voltec kernel: Detected scsi removable disk sdb at scsi0, channel 0, id 5, lun 0
Jan 28 12:04:35 voltec kernel: scsi : detected 1 SCSI tape 2 SCSI disks total.
Jan 28 12:04:35 voltec kernel: SCSI device sda: hdwr sector= 512 bytes. Sectors= 4194685 [2048 MB] [2.0 GB]
Jan 28 12:04:35 voltec kernel: sdb : READ CAPACITY failed.
Jan 28 12:04:36 voltec kernel: sdb : status = 1, message = 00, hos sdb4
---------------------
